Removing A Tape Drive - IBM System x3200 Type 4362 Problem Determination And Service Manual
Ibm mini tower server problem determination and service guide
Hide thumbs
Also See for System x3200 Type 4362:
- Installation manual (100 pages) ,
- User manual (84 pages)
Table of Contents
Advertisement
10. Install and lock the side cover (see "Installing the side cover" on page 40).
11. Reconnect the external cables and power cords; then, turn on the attached
Removing a tape drive
To remove a tape drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Unlock and remove the side cover (see "Installing the side cover" on page 40).
4. Remove the upper bezel (see "Installing the upper bezel" on page 44).
5. Remove the lower bezel (see "Installing the lower bezel" on page 42).
6. Disconnect the power and signal cables from the drive that is to be removed.
7. Press and hold the blue release button on the side of the bay to release the
8. Remove the drive retainer clip from the side of the drive. Save the clip to use
9. If you are instructed to return the drive, follow all packaging instructions, and
56
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
7. Connect the power and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of
the drives or over the microprocessor and dual inline memory modules
(DIMMs).
8. Install the upper bezel (see "Installing the upper bezel" on page 44).
9. Install the lower bezel (see "Installing the lower bezel" on page 42).
devices and turn on the server.
Drive retainer clip
on page 35.
all external cables.
drive; then, pull the drive out of the front of the server.
when you install the replacement drive.
use any packaging materials for shipping that are supplied to you.
EMC shield
Tape drive
Hide quick links:
Advertisement
Table of Contents
