Ipv6 Setup - Cisco TES301 User Manual
Ip managed services home gateway
Hide thumbs
Also See for TES301:
- User manual (98 pages) ,
- User manual (92 pages) ,
- Quick reference manual (2 pages)
Table of Contents
Advertisement
Chapter 4 Configuring Advanced Settings
IPv6 Setup
Field
IPv6 WAN
Listen to Router
Advertisement
Static Configuration
DHCPv6 Client
DUID
58
Description
Select Enabled (default) to allow the WAN interface to accept
router advertisements. Otherwise, select Disabled.
Select Enabled to activate the fields for this option. Otherwise,
select Disabled (default).
Choose from the following options:
WAN address/prefix_length—Specify wan side IPv6
address with length of the prefix used for network part. The
format must be as follows:
xxxx:xxxx:xxxx::xxxx/num
WAN Default router—Specify wan side IPv6 router address
the packet will be sent.
LAN address/prefix_length—Specify lan side IPv6 address
with length of the prefix used for network part.
Choose from the following options:
Disabled—No DHCPv6 running on WAN interface. User
will get IPv6 address either through stateless auto config or
static config.
PD Enabled—DHCPv6 will run on WAN interface to get
prefix delegation information which will be used to decide
lan side IPv6 address.
IA Enabled—DHCPv6 will run on WAN interface to get
identity aggregation info from DHCPv6 server to use it to
decide WAN interface IPv6 address.
IA+PD Enabled—DHCPv6 will run on WAN interface to
get both identity aggregation and prefix delegation
information.
Stateless—DHCPv6 client will auto-configure IP address
based on router advertisements or manual configuration
instead of requesting IP address from DHCP server.
DHCPv6 Client under this mode will only send
Information-request message for configuration parameters
from DHCPv6 server.
WAN-interfacing device unique identifier. If you choose to
change it, the format must be as follows:
00:03:00:01:xx:xx:xx:xx:xx:xx
4038767 Rev B
Advertisement
Table of Contents
