Mode Setting; Input/Output Specifications - Sony XC-HR90 Technical Manual
Ccd black-and-white
video camera module
Hide thumbs
Also See for XC-HR90:
- Technical manual (41 pages) ,
- Manual (4 pages) ,
- Operating instructions (2 pages)
Table of Contents
Advertisement
It is recommended that you make a test under the
conditions you will operate the camera before actually
using it.
Input/Output
Specifications
External HD/VD Input
Specifications
Note that input outside the specified ranges can lead to
internal reset instability and malfunction of the RS-
232C communication.
However, when you input an external HD/VD phase
signal in all modes, the video out signals are output
about 1 H later than the external VD.
During normal operation (30 fps mode)
HD phase: 33.67 µ sec/37.32 µ sec (binning OFF/ON)
VD phase: 33.33 m sec/18.47 m sec (binning OFF/ON)
During normal operation (15 fps mode)
HD phase: 67.34 µ sec
VD phase: 66.66 m sec/33.33 m sec (binning OFF/ON)
continuous
During restart/reset or external trigger shutter
mode operation
HD phase: 33.67 µ sec (30 fps normal), 37.32 µ sec (30
fps binning), 67.34 µ sec (15 fps normal/
binning) continuous
VD phase: VD (reset) only timing where the HD phase
is within range shown above.
Mode Setting
External HD/VD Output
Specifications
HD
VD
The amplitude level is the typical value when
terminated with 10 kΩ. External HD and VD can be
output when you set the HD/VD signal input/output
switch of the Mode setting DIP switches to INT
(down position).
The voltage and pulse width used are as measured at
pin 6 (HD) and pin 7 (VD) of the 12-pin multi-
connector on the rear panel.
WEN Output Specifications
990 H (Binning OFF)
495 H (Binning ON)
The amplitude level is the typical value when
terminated with 10 kΩ. The pulse width is undefined
during partial scan mode, but WEN rising edge is
always synchronized with internal VD at the start of
image output.
4.0V
0 – 0.6V
4.0V
0 – 0.6V
4.0V
0 – 0.6V
10
Advertisement
Table of Contents
