Sony XC-HR90 Technical Manual page 9
Ccd black-and-white
video camera module
Hide thumbs
Also See for XC-HR90:
- Technical manual (41 pages) ,
- Manual (4 pages) ,
- Operating instructions (2 pages)
Table of Contents
Advertisement
Camera Control Method
You can control the camera module from host device
such as a PC. The following table shows the control
functions. You can send a command corresponding to
the control items, with parameters for the desired
setting, if necessary, from the host device to control the
camera.
Control function Description
Operating mode
Normal/Restart reset/trigger mode 1/ trigger
mode 2
Shutter speed
Normal 30 fps mode: OFF (1/30) to
Trigger
Gain
0 to +18 dB
Binning function
OFF/ON
Partial Scan
OFF/ON The area can be divided into 16
function
segments.
HD/VD signal
External sync signal input/Internal sync
I/O signal input
75Ω termination
ON/OFF
Frame rate
30 fps/15 fps
Notes
Make sure to supply power to the camera module and
confirm that the camera module is operating before
inputting a sync or trigger signal. If you input external
signals to a camera module without the power
supplied, this may cause malfunction of the camera
module.
Be sure to turn off the power of the camera before
changing the settings of the RS-232C ON/OFF switch
and the 30 fps/15 fps switch.
IMPORTANT
When you control the camera using both an external
synchronous signal and the host device (e.g., a PC), be
sure to use the camera within the specified frequency
range. If the camera receives signals in frequencies
other than the specified one, the camera cannot be
controlled.
1/100000
15 fps: OFF (1/15) to 1/50000
Internal setting: OFF (the same as
above) to 1/100000
Setting by trigger pulse width
Overview
9
Advertisement
Table of Contents
