Table of Contents
Advertisement
Quick Links
Dustless Circular Saw
Model C 5YC
Handling Instructions
Note:
Before using this Electric Power Tool, carefully read through these
HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is
recommended that these INSTRUCTIONS be kept readily available
as an important reference when using this power tool.
Advertisement
Table of Contents
Related Manuals for Hitachi C 5YC
Summary of Contents for Hitachi C 5YC
-
Page 1: Handling Instructions
Dustless Circular Saw Model C 5YC Handling Instructions Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Operational Precautions
17. Avoid unintentional starting. Do not carry a plugged- GENERAL OPERATIONAL PRECAUTIONS in tool with a finger on the switch. Ensure switch is off when plugging in. WARNING! When using electric tools, basic safety 18. Use outdoor extension leads. When tool is used precautions should always be followed to reduce the outdoors, use only extension cords intended for risk of fire, electric shock and personal injury, including... -
Page 3: Name Of Parts
NAME OF PARTS Handle Switch Name plate Housing Gear cover Saw cover Motor Brush holder Lock lever Link Wing bolt Lever Base Clamp lever Brush cap Lower guard Wing bolt Saw blade Inclined gauge Slide cover Bevel piece Guide SPECIFICATIONS Voltage (by areas)* (230 V, 240 V) Cutting Depth... -
Page 4: Prior To Operation
APPLICATION (1) Cutting the hard boards types T9 and T7. (ex. harditex, hardiflex, etc.) Loosen (2) Cutting the gypsum board. PRIOR TO OPERATION Tighten 1. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product Link nameplate. -
Page 5: Cutting Procedures
CUTTING PROCEDURES CAUTION During use, when the body is out of condition or there Guide is unusual sound, please turn off a switch immediately. During cutting, please do not pry the body or do not push too much strongly. Please carry forward the body calmly straightly. -
Page 6: Use Of Dust Bag
1. How to attach (Fig. 8) (4) Saw blade is attached (Fig. 11) (1) The cut depth is made into the minimum. A lower guard is carried out to full open, and saw A lever is loosened, a base is made into the minimum blade is attached. -
Page 7: Maintenance And Inspection
4. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement on this tool should ONLY be performed by a Hitachi Authorized Service Center. 5. Replacing supply cord If the supply cord of Tool is damaged, the Tool must be returned to Hitachi Authorized Service Center for the cord to be replaced. - Page 9 ITEM ITEM PART NAME PART NAME SAW COVER SUPER LOCK WASHER M6 BOLT (LEFT HAND) W/WASHER M7 × 17.5 WING BOLT (A) WASHER (A) HANDLE COVER WASHER (B) SWITCH SLOTTED HD. SET SCREW (SEAL LOCK) M6 × 6 DUST WASHER O-RING (1AP-20) BOLT WASHER M8 MACHINE SCREW (W/WASHER) M4 ×...
- Page 12 Hitachi Koki Co., Ltd. Code No. C99120611 N Printed in Japan...