Toro 22196 Operator's Manual page 11

21in heavy-duty recycler/rear bagger lawn mower

Hide thumbs Also See for 22196:

Table of Contents

Enlarged version

1. Dipstick

2. Upper limit mark

Note: When the crankcase is empty, pour about 3/4 of the

crankcase capacity of oil in the crankcase, then follow the

procedure in this section.

1. Move the machine to a level surface.

2. Clean around the dipstick (Figure 9).

3. Remove the dipstick by rotating the cap

counterclockwise and pulling it out.

4. Wipe the dipstick clean with a clean cloth.

5. Insert the dipstick into the filler neck (but do not

rotate the cap clockwise to secure it), then remove it.

6. Read the oil level on the dipstick.

7. If the oil level reading is below the lower limit mark on

the dipstick, remove the dipstick and slowly pour only

enough oil into the filler hole to raise the oil level to

the upper limit mark on the dipstick.

Important: Do not overfill the crankcase with oil

and run the engine; engine damage will result.

Drain the excess oil until the oil level reaches the

upper limit mark on the dipstick.

8. Insert the dipstick into the filler neck and rotate the cap

clockwise until it is tight.

Figure 9

3. Lower limit mark

Table of Contents