Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Toro 22200TE
Summary of Contents for Toro 22200TE
- Page 1 Form No. 3362-483 Rev A 66cm Heavy-Duty Rear Bagger Lawn Mower Model No. 22200TE—Serial No. 290000501 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Sound Power ............5 additional information, contact an Authorized Service Vibration, Hand/arm ........... 5 Dealer or Toro Customer Service and have the model Safety and Instructional Decals ......6 and serial numbers of your product ready. Figure 1 Setup................8 identifies the location of the model and serial numbers 1 Installing the Handle.......... -
Page 3: Safety
General Information .......... 26 comply with these safety instructions. Removing the Mower from Storage..... 26 Toro designed and tested this mower for reasonably safe Troubleshooting............27 service; however, failure to comply with the following instructions may result in personal injury. -
Page 4: Maintenance And Storage
• If gasoline is spilled, do not attempt to start the – Do not mow excessively steep slopes. engine but move the mower away from the area of – Exercise extreme caution when on slopes. spillage and avoid creating any source of ignition –... -
Page 5: Sound Pressure
• To ensure the best performance and safety, purchase only genuine Toro replacement parts and accessories. Do not use will fit parts and accessories; they may cause a safety hazard. -
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the original machine manufacturer. - Page 7 112-8760 1. Thrown object hazard—keep bystanders a safe distance from the machine. 2. Cutting/dismemberment of hand or foot—stay away from moving parts. 112-9028 1. Warning—stay away from moving parts; keep all guards in place. 115-4207 1. Read the Operators 3. Lubricate the transmission Manual.
-
Page 8: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Handle Install the handle. – No parts required Fill the crankcase with oil. Note: Determine the left and right sides of the machine from the normal operating position. -
Page 9: Product Overview
Controls Product Overview Figure 5 Figure 4 1. Ground speed control 4. Handle lever 1. Handle 8. Starter handle 2. Blade control lever 5. Traction control bar 2. Traction control bar 9. Air filter 3. Blade control bar 6. Throttle control lever 3. -
Page 10: Operation
Operation Note: Determine the left and right sides of the machine from the normal operating position. Each time before you mow, make sure that the self-propel drive and the blade control bar and blade control lever operate properly. When you release the blade control bar, the blade and self-propel drive should stop. -
Page 11: Filling The Fuel Tank With Gasoline
Filling the Fuel Tank with Gasoline When fueling, under certain circumstances, a For best results, use clean, fresh, lead-free gasoline with static charge can develop, igniting the gasoline. A fire or explosion from gasoline can burn you an octane rating of 87 or higher. To ensure freshness, and others and damage property. -
Page 12: Starting The Engine
Figure 9 Figure 11 1. Fuel tank cap 1. Fuel valve 2. Remove the cap from the tank. 3. Move the throttle control lever to the Choke position (Figure 6). 3. Fill the fuel tank with unleaded gasoline to within 1/4 to 1/2 inch (6 to 13 mm) from the top of the Note: You do not need to use the choke when the tank. -
Page 13: Operating The Blade
Operating the Blade Disengaging the Blade Release the blade control bar. Engaging the Blade Important: When you release the blade control bar, the blade should stop within 3 seconds. If it Service Interval: Before each use or daily does not stop properly, stop using your mower Note: When you start your engine, the blade does not immediately and contact an Authorized Service turn. -
Page 14: Checking The Blade Brake Clutch
Checking the Blade Brake Clutch Adjusting the cutting height levers could bring your hands into contact with a moving blade Check the blade control bar and the blade control lever and result in serious injury. before each use to ensure that the blade brake clutch system is operating properly. -
Page 15: Using The Grass Bag
Using the Grass Bag Check the grass bag frequently. If it is damaged, install a new Toro replacement bag. Installing the Grass Bag 1. Wait for all moving parts to stop. Operating Tips 2. -
Page 16: Cutting Grass
Cutting Leaves • Keep the engine in good running condition. • Set the engine speed to the fastest position for the • After cutting the lawn, ensure that half of the lawn best cutting results. shows through the cut leaf cover. You may need to make more than one pass over the leaves. -
Page 17: Maintenance
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •... -
Page 18: Lubrication
Lubrication Lubricating the Gear Case Service Interval: Every 50 hours Lubricating the Pivot Arms After every 50 operating hours, grease the gear case. Service Interval: Every 50 hours 1. Remove the grass bag. After every 50 operating hours or when the season ends, 2. -
Page 19: Engine Maintenance
Engine Maintenance 10. Install the cover and secure it with the screw. 11. Connect the wire to the spark plug. Servicing the Air Filter Changing the Engine Oil Service Interval: Every 100 hours Service Interval: After the first 5 hours Every 300 hours Every 50 hours Clean the foam pre-cleaner every 25 operating hours. -
Page 20: Changing The Oil Filter
8. After draining the oil, return the mower to the 8. Install the new filter and hand tighten it 2/3 turn operating position. only. 9. Close the drain valve and remove the drain hose. 9. Fill the crankcase to the Full line on the dipstick with fresh oil Refer to Filling the Crankcase with Oil. -
Page 21: Fuel System Maintenance
Fuel System Drive System Maintenance Maintenance Emptying the Fuel Tank and Adjusting the Self-propel Drive Cleaning the Fuel Filter Service Interval: Every 75 hours Service Interval: Yearly If the mower does not self-propel or has a tendency to creep forward when the traction control bar is more Every 50 hours than 1-1/2 inches (38 mm) from the handle, adjust the Every 300 hours... -
Page 22: Controls System Maintenance
Blade Maintenance Controls System Maintenance Maintaining the Cutting Blade Adjusting the Blade Brake Always mow with a sharp blade. A sharp blade cuts cleanly and without tearing or shredding the grass blades. Cable 1. Stop the engine and wait for all moving parts to stop. Service Interval: Before each use or daily 2. -
Page 23: Removing The Blade
A worn or damaged blade can break, and a piece of the blade could be thrown into the operator’s or bystander’s area, resulting in serious personal injury or death. • Inspect the blade periodically for wear or damage. • Replace a worn or damaged blade. Removing the Blade Figure 27 Grasp the end of the blade using a rag or a thickly... -
Page 24: Cleaning
Installing the Blade Cleaning 1. Install a sharp, balanced Toro blade, the washer, anti-scalp cup, and blade nuts. The sail of the blade Cleaning under the Belt Cover must point toward the top of the mower housing for proper installation. Torque the blade bolt to 75 to 85 Service Interval: Every 50 hours ft-lb (102 to 115 N-m). -
Page 25: Cleaning The Discharge Tunnel
Cleaning the Discharge Tunnel Service Interval: Before each use or daily Clean the discharge tunnel after each use. Ensure that the discharge tunnel door closes securely Figure 32 when you remove the bag. If the debris prevents the 1. Right rear wheel discharge door from closing securely, clean the inside of the discharge tunnel and the door thoroughly. -
Page 26: Storage
General Information Storage 1. Clean the mower housing. Refer to Cleaning under To prepare the mower for off-season storage, perform the Mower Housing. the recommended maintenance procedures. Refer to 2. Clean any dirt and chaff from the cylinder, cylinder Maintenance. head fins, and blower housing. -
Page 27: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The engine does not start 1. The fuel tank is empty or the fuel 1. Drain and/or fill the fuel tank with system contains stale fuel. fresh gasoline. If the problem persists, contact an Authorized Service Dealer. 2. - Page 28 Notes:...
- Page 29 Notes:...
- Page 30 Notes:...
- Page 31 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev D...
- Page 32 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.