Table of Contents
Advertisement
Connecting Dial-In and Dial-Out Modems
The following are the commands used for the V.34R with a talk/data push button for the Auto-Dial
Configuration (dial-out to customer service):
Command
AT&F
ATL1
AT\N3
AT%C
AT\J
AT\Q1
AT\T3
AT&C1
AT&D2
AT&V
AT&W
Note
Disconnect the terminal and the straight-through cable from the control port.
Step 11
Connect the modem to the AUX port by using a null modem cable as shown in Figure 15-6.
Step 12
Step 13
Contact Cisco Customer Service to assist in testing the operation of the modem setup.
Cisco BPX 8600 Series Installation and Configuration
15-16
Function
Initialize the factory defaults.
Set the volume for the modem speaker to minimum.
Enable the automatic MNP error correction.
Disable the data compression.
Enable the DTE speed conversion.
Enable the XON/XOFF flow control.
Enable the 3-minute inactivity timer.
Specify that the DCD is controlled by a modem.
Ensure that the modem disconnects when DTR is toggled.
Verify entries. (shows current configuration).
Save the current settings to nonvolatile memory.
Consult the manual supplied with your modem for specifics concerning the modem
configuration. Contact Cisco Customer Service for the current modem configuration
information.
Chapter 15
Connecting Temporary Terminal and Attaching Peripherals
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Advertisement
Table of Contents
Troubleshooting
