Maintenance And Service; Replacing The Rf182C Communication Module - Siemens RF182C Operating Instructions Manual

Rfid systems

Table of Contents

Maintenance and Service

7.1

Initial situation

● The RF182C communication module is already mounted. A new RF182C communication

● The RF182C is wired up and operating.

Procedure

1. Remove the 4 fixing screws from the connection block and pull the connection block off

2. On the communication module, remove the screwed M12 plug-in connections to the

3. Remove the fixing screws from the communication module and remove it.

4. Locate the new communication module and screw it down firmly.

5. Place the connection block on the new communication module and tighten the 4 fixing

Result

Since the IP address of the communication module remains saved in the connection block,

the new RF182C communication module is included in the data communication by the

Ethernet controller.

Note

If the connection block is replaced in addition to the base unit, the RF182C may not start up

automatically. In this case, proceed as follows:

RF182C communication module

Operating Instructions, 10/2010

module of the same type should be installed.

the communication module.

Note

If you disassemble the connection block during operation, only the power supply will be

looped through. Ethernet communication will be interrupted during module replacement

from this node onwards. For more information, refer to section Loop-through of Ethernet

and supply voltage (Page 30).

readers.

screws.

Table of Contents

Show Quick Links

Table of Contents