IBM pSeries 690 Service Manual page 401

Hide thumbs Also See for pSeries 690:

Service manual (1080 pages)

User manual (277 pages)

Installation manual (230 pages)

page of 1134

/ 1134
Contents
Table of Contents
Bookmarks

Table of Contents

Table 2. Firmware Checkpoints (continued)

XOFF received - waiting for XON

XON received

Probe for (ISA) keyboard

Probe for (ISA) mouse

Build ISA timer chip node

Create ISA interrupt controller (pic) node

Create DMA node

Create PCI SCSI node

Create SCSI block device node (SD)

Possible Failing FRU

1. The system firmware is waiting for a

virtual terminal to be opened on the

HMC. Open a virtual terminal.

2. If a virtual terminal is open, the user

might have entered a CTRL-S key

sequence to stop the scrolling of data

off of the screen. If this is the case,

enter a CTRL-Q key sequence to

resume scrolling.

3. Check the serial connection between

the HMC and the managed system.

4. Reboot the HMC.

5. There may be a hardware problem with

the HMC. Refer to the IBM Hardware

Management Console for pSeries

Installation and Operations Guide.

6. There may be a hardware problem with

the service processor in the managed

system. Check the service action event

codes that indicate a problem with the

serial ports on the service processor.

The service processor is in the primary

I/O book at the U1.18-P1-H2 location.

Take the appropriate actions based on

the error codes that are found.

This checkpoint will flash by too quickly to

be seen on the operator panel. It may be

recorded in the progress indicators log,

which is accessed using the service

processor menus. If a partition hangs on

this checkpoint, complete the following:

1. Check for platform firmware updates.

Apply if available.

2. Call service support.

Replace the primary I/O book,

Location: U1.18-P1-H2.

Replace the primary I/O book,

Location: U1.18-P1-H2.