Siemens SINUMERIK 808D ADVANCED Commissioning Manual page 267
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
Measuring the Y axis of the tool
→
Commissioning Manual
01/2017
Move the cursor to the input field for Length X with the cursor keys and then press this soft-
key.
12.
Enter the distance measured in Step 9 in the input field (for example, 48).
If you desire to use the relative coordinate, press this softkey.
13.
Press this softkey to confirm your input. The system calculates the offset and enters it in the
geometry input field of the currently active tool automatically.
1.
Select the machining operating area.
2.
Switch to "MDA" mode and enter "SPOS=0" in the program editor window to fix the spindle.
3.
Switch to handwheel control mode.
4.
Select a suitable override feedrate.
5.
Use the handwheel to move the tool to approach the workpiece and cut the surface of the
workpiece for about 1 mm along the X axis. Then retract the tool along the X axis.
Note:
Make sure you do not move the tool along the Y axis afterwards.
6.
Switch to "MDA" mode and continue to enter "SPOS=180" in the program editor window.
7.
Press this key to rotate the spindle 180 degrees.
8.
Repeat Steps 3 to 5.
9.
Measure the distance between the two cutting surfaces machined in the previous steps with
a calliper.
267
Advertisement
Table of Contents
