hit counter script

Operation - Honeywell HZ-0360 Series Operating And Safety Instructions Manual

360 grad surround heat heater
Hide thumbs Also See for HZ-0360 Series:
Table of Contents

Advertisement

Available languages

Available languages

SET-UP
• Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m)
away from any wall or any combustible material. DO NOT use on an unstable surface such as
bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY
CHILDREN OR PETS.
MOVING THE HEATER
• Turn off the heater.
• Allow it to cool for ten minutes.
• Unplug heater and move.

OPERATION

• NOTE: The 360° Surround Heat™ Heater requires no
assembly.
• NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
• The 360° Surround Heat™ Heater is designed to disperse heat
in a 360° range.
• With the Power Knob in the OFF (
into a polarized 120V outlet.
DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET;
it will only fit one way.
• The Power Knob is equipped with three (3) settings:
Fan Only (
Low ( )
High (
)
The Low ( ) setting uses 750 watts of power and the High (
power. Fan Only (
accommodate your comfort level with the Power Knob. When you choose any setting the amber
Power Light will come on. Because the Low ( ) setting does not require as much electricity to
operate, it is more energy efficient and may be a better option if you are concerned about the
amperage draw on a circuit when the heater is on the High (
• Turn the Thermostat Control fully clockwise to the highest (
• When the room reaches a comfortable temperature, slowly turn the Thermostat Control
counter-clockwise until the heating element goes off (the amber Power Light will not be shut off).
This is the point at which the Thermostat setting equals the room temperature. At this setting,
the Thermostat will automatically turn the heater on and off to maintain the selected temperature.
• Turn the Power Knob to OFF (
o
) position, plug the heater
)
) setting uses 19 watts of power. You can select the proper setting to
o
) and unplug the heater when you are finished using it.
Fig. 1
Thermostat Control
Power Knob
) setting uses 1500 watts of
) setting.
) setting.
Power
Light

Advertisement

Table of Contents
loading

Table of Contents