Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
Use one of the following:
• access-list access-list-number {deny | permit}
source [source-wildcard]
• access-list access-list-number {deny | permit}
protocol source [source-wildcard] destination
[destination-wildcard]
• ipv6 access-list access-list-name {deny |
permit} protocol
{source-ipv6-prefix/prefix-length | any | host
source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/
prefix-length | any | host
destination-ipv6-address} [operator
[port-number]] [dscp value] [fragments] [log]
[log-input] [routing] [sequence value]
[time-range name]
• mac access-list extended name {permit |
deny} {host src-MAC-addr mask | any | host
dst-MAC-addr | dst-MAC-addr mask} [type
mask]
Example:
Switch(config)# access-list 103 permit ip
any
any dscp 10
Step 3
class-map [match-all | match-any] class-map-name
Example:
Switch(config)# class-map class1
Purpose
Enters the global configuration mode.
Creates an IP standard or extended ACL, an IPv6 ACL for IP traffic,
or a Layer 2 MAC ACL for non-IP traffic, repeating the command
as many times as necessary.
When creating an access list, remember that, by default, the end of
the access list contains an implicit deny statement for everything if
it did not find a match before reaching the end.
Creates a class map, and enters class-map configuration mode.
By default, no class maps are defined.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
• (Optional) Use the match-all keyword to perform a logical-AND
of all matching statements under this class map. All match
criteria in the class map must be matched.
• (Optional) Use the match-any keyword to perform a logical-OR
of all matching statements under this class map. One or more
match criteria must be matched.
• For class-map-name, specify the name of the class map.
How to Configure QoS
593
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
