Configuring Etherchannels - Cisco Catalyst 3750 Software Configuration Manual
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Configuring EtherChannels
Figure 27-3 Load Distribution and Forwarding Methods
Configuring EtherChannels
These sections describe how to configure EtherChannel on Layer 2 and Layer 3 ports:
•
•
•
•
•
•
•
Note
Make sure that the ports are correctly configured. For more information, see the
Configuration Guidelines" section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Catalyst 3750 Metro Switch Software Configuration Guide
27-8
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 27-9
EtherChannel Configuration Guidelines, page 27-9
Configuring Layer 2 EtherChannels, page 27-10
Configuring Layer 3 EtherChannels, page 27-12
Configuring EtherChannel Load Balancing, page 27-15
Configuring the PAgP Learn Method and Priority, page 27-16
Configuring LACP Hot-Standby Ports, page 27-17
(required)
(required)
(optional)
(optional)
(optional)
27-9.
Chapter 27
Configuring EtherChannels
"EtherChannel
78-15870-01
Advertisement
Table of Contents
Troubleshooting
