Cisco Catalyst 3750 Software Configuration Manual page 693
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Chapter 28
Configuring IP Unicast Routing
Note
Although each of Steps 3 through 14 in the following section is optional, you must enter at least one
match route-map configuration command and one set route-map configuration command.
Beginning in privileged EXEC mode, follow these steps to configure a route map for redistribution:
Command
Step 1
configure terminal
Step 2
route-map map-tag [permit | deny] [sequence number] Define any route maps used to control redistribution and
Step 3
match as-path path-list-number
Step 4
match community-list community-list-number [exact]
Step 5
match ip address {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Step 6
match metric metric-value
Step 7
match ip next-hop {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Step 8
match tag tag value [...tag-value]
Step 9
match interface type number [...type number]
Step 10
match ip route-source {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Step 11
match route-type {local | internal | external [type-1 |
type-2]}
78-15870-01
Configuring Protocol-Independent Features
Purpose
Enter global configuration mode.
enter route-map configuration mode.
map-tag—A meaningful name for the route map. The
redistribute router configuration command uses this
name to reference this route map. Multiple route maps
might share the same map tag name.
(Optional) If permit is specified and the match criteria
are met for this route map, the route is redistributed as
controlled by the set actions. If deny is specified, the
route is not redistributed.
sequence number (Optional)— Number that indicates the
position a new route map is to have in the list of route
maps already configured with the same name.
Match a BGP AS path access list.
Match a BGP community list.
Match a standard access list by specifying the name or
number. It can be an integer from 1 to 199.
Match the specified route metric. The metric-value can be
an IGRP five-part metric with a specified value from 0 to
4294967295.
Match a next-hop router address passed by one of the
access lists specified (numbered from 1 to 199).
Match the specified tag value in a list of one or more route
tag values. Each can be an integer from 0 to 4294967295.
Match the specified next hop route out one of the
specified interfaces.
Match the address specified by the specified advertised
access lists.
Match the specified route-type:
local—Locally generated BGP routes.
•
internal—OSPF intra-area and interarea routes or
•
EIGRP internal routes.
external—OSPF external routes (Type 1 or Type 2)
•
or EIGRP external routes.
Catalyst 3750 Metro Switch Software Configuration Guide
28-91
Advertisement
Table of Contents
Troubleshooting
