Quality of Service (QoS)
Configuring Session Limits
STEP 4
Configuring Session Limits
STEP 1
STEP 2
STEP 3
Cisco RV315W Broadband Wireless VPN Router Administration Guide
-
IP Address: Controls flow based on the specified IP addresses of the
hosts. If you select this option, enter the starting and ending IP addresses
in the Start Address and End Address fields and select a LAN interface
from the LAN Interface drop-down menu.
•
Application Queue: Applies this flow control policy to an interface queue.
Select a queue from the drop-down menu.
•
Tag Type: Check Enable to enable Tag Type, or check Disable to disable this
feature.
•
New Tag Value: If you enable Tag Type, specify the method how to assign
the priority for traffic:
-
CoS: Choose the CoS remarking value to assign the priority for traffic.
-
DSCP: Choose the DSCP remarking value to assign the priority for traffic.
Click OK to save your settings and return to the Flow Control Policies page.
Use the Session Limits page to configure the maximum number of connection
sessions for the complete system, for a range of IP addresses, or for each physical
port. When the connection table is full, the new sessions that access the RV315W
are dropped.
To limit the maximum number of connection sessions:
Click QoS > Session Limits. The Session Limits page opens.
Check Enable to limit the number of connection sessions, or check Disable to
disable this feature.
If you enable this feature, enter the following information:
•
IP-based Limit: Specify the maximum number of connection sessions
allowed on each IP address and/or the range of IP addresses.
•
Port-based Limit: Specify the maximum number of connection sessions
allowed on each physical port.
•
Maximum Sessions: Specify the maximum number of connection sessions
allowed on the complete system.
7
75