Configuring Rspan - Cisco Catalyst 3550 series Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550 series:
- Reference manual (58 pages) ,
- Datasheet (21 pages) ,
- Manual (19 pages)
Table of Contents
Advertisement
Configuring RSPAN
Configuring RSPAN
This section describes how to configure RSPAN on your switch. It contains this configuration
information:
•
•
•
•
•
•
•
RSPAN Configuration Guidelines
Follow these guidelines when configuring RSPAN:
•
As RSPAN VLANs have special properties, you should reserve a few VLANs across your network for
Note
use as RSPAN VLANs; do not assign access ports to these VLANs.
You can apply an output access control list (ACL) to RSPAN traffic to selectively filter or monitor
Note
specific packets. Specify these ACLs on the RSPAN VLAN in the RSPAN source switches.
•
•
•
•
•
•
•
•
Catalyst 3550 Multilayer Switch Software Configuration Guide
24-16
RSPAN Configuration Guidelines, page 24-16
Creating an RSPAN Session, page 24-17
Creating an RSPAN Destination Session, page 24-18
Creating an RSPAN Destination Session and Enabling Ingress Traffic, page 24-19
Removing Ports from an RSPAN Session, page 24-20
Specifying VLANs to Monitor, page 24-21
Specifying VLANs to Filter, page 24-22
All the items in the
"SPAN Configuration Guidelines" section on page 24-9
RSPAN sessions can coexist with SPAN sessions within the limits described in the
RSPAN Session Limits" section on page
For RSPAN configuration, you can distribute the source ports and the destination ports across
multiple switches in your network.
A port cannot serve as an RSPAN source port or RSPAN destination port while designated as an
RSPAN reflector port.
When you configure a switch port as a reflector port, it is no longer a normal switch port; only
looped-back traffic passes through the reflector port.
RSPAN does not support BPDU packet monitoring or other Layer 2 switch protocols.
The RSPAN VLAN is configured only on trunk ports and not on access ports. To avoid unwanted
traffic in RSPAN VLANs, make sure that the VLAN remote-span feature is supported in all the
participating switches. Access ports on the RSPAN VLAN are silently disabled.
RSPAN VLANs are included as sources for port-based RSPAN sessions when source trunk ports
have active RSPAN VLANs. RSPAN VLANs can also be sources in SPAN sessions.
You can configure any VLAN as an RSPAN VLAN as long as these conditions are met:
No access port is configured in the RSPAN VLAN.
–
The same RSPAN VLAN is used for an RSPAN session in all the switches.
–
All participating switches support RSPAN.
–
Chapter 24
24-8.
Configuring SPAN and RSPAN
apply to RSPAN.
"SPAN and
78-11194-09
Advertisement
Table of Contents
Troubleshooting
