Configuring Wred Drop Thresholds Percentages - Cisco Catalyst 3550 series Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550 series:
- Reference manual (58 pages) ,
- Datasheet (21 pages) ,
- Manual (19 pages)
Table of Contents
Advertisement
Chapter 29
Configuring QoS
As a result of this configuration, when queue 1 is filled above 10 percent, packets with DSCPs 0, 8, 16,
24, 32, 40, 48, and 56 are dropped. The same packets are dropped when queue 2 is filled above 40
percent, queue 3 above 60 percent, and queue 4 above 80 percent. When the second threshold (100
percent) is exceeded, all queues drop packets with DSCPs 10, 20, 30, 40, 50, and 60.
Configuring WRED Drop Thresholds Percentages
WRED reduces the chances of tail drop by selectively dropping packets when the output interface begins
to show signs of congestion. By dropping some packets early rather than waiting until the queue is full,
WRED avoids dropping large numbers of packets at once.
All packets with DSCPs assigned to the first threshold are randomly dropped when the first threshold is
exceeded. However, packets with DSCPs assigned to the second threshold continue to be queued and
sent as long as the second threshold is not exceeded. Each threshold percentage represents where WRED
starts to randomly drop packets. By default, WRED is disabled.
If you use WRED, you cannot use tail-drop thresholds, and vice versa.
Beginning in privileged EXEC mode, follow these steps to configure the WRED drop threshold
percentage values on Gigabit-capable Ethernet ports:
Command
Step 1
configure terminal
Step 2
mls qos
Step 3
interface interface-id
Step 4
wrr-queue random-detect
max-threshold queue-id
threshold-percentage1
threshold-percentage2
Step 5
exit
Step 6
interface interface-id
Step 7
wrr-queue dscp-map threshold-id dscp1
... dscp8
78-11194-09
Purpose
Enter global configuration mode.
Enable QoS on the switch.
Enter interface configuration mode, and specify the egress
Gigabit-capable Ethernet interface.
Configure WRED drop threshold percentages on each egress queue.
The default, WRED is disabled, and no thresholds are configured.
•
For queue-id, specify the ID of the egress queue. The range is 1
to 4, where queue 4 can be configured as the expedite queue. For
more information, see the
Queue" section on page
For threshold-percentage1 threshold-percentage2, specify the
•
threshold percentage values. Separate each value with a space. The
range is 1 to 100.
Return to global configuration mode.
Enter interface configuration mode, and specify the ingress
Gigabit-capable Ethernet interface.
Map DSCP values to the WRED drop thresholds of the egress queues.
By default, all DSCP values are mapped to threshold 1.
For threshold-id, specify the threshold ID of the queue. The range
•
is 1 to 2.
•
For dscp1 ... dscp8, specify the DSCP values that are mapped to the
threshold ID. Enter up to eight DSCP values per command.
Separate each value with a space. The range is 0 to 63.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring Standard QoS
"Configuring the Egress Expedite
29-62.
29-61
Advertisement
Table of Contents
Troubleshooting
