Backbone Area; Stub Area; Not-So-Stubby Area; Routers - Cisco ASR 9000 Series Configuration Manual
Aggregation services router
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing OSPF
traffic. It also reduces the size of the topology information in each router, conserving processing and memory
requirements in each router.
Also, the routers within an area cannot see the detailed network topology outside the area. Because of this
restricted view of topological information, you can control traffic flow between areas and reduce routing
traffic when the entire autonomous system is a single routing domain.
Backbone Area
A backbone area is responsible for distributing routing information between multiple areas of an autonomous
system. OSPF routing occurring outside of an area is called interarea routing.
The backbone itself has all properties of an area. It consists of ABRs, routers, and networks only on the
backbone. As shown in
area. Any OSPF backbone area has a reserved area ID of 0.0.0.0.
Stub Area
A stub area is an area that does not accept route advertisements or detailed network information external to
the area. A stub area typically has only one router that interfaces the area to the rest of the autonomous system.
The stub ABR advertises a single default route to external destinations into the stub area. Routers within a
stub area use this route for destinations outside the area and the autonomous system. This relationship conserves
LSA database space that would otherwise be used to store external LSAs flooded into the area. In
OSPF Routing Components, on page
cannot be a stub area.
Not-so-Stubby Area
A Not-so-Stubby Area (NSSA) is similar to the stub area. NSSA does not flood Type 5 external LSAs from
the core into the area, but can import autonomous system external routes in a limited fashion within the area.
NSSA allows importing of Type 7 autonomous system external routes within an NSSA area by redistribution.
These Type 7 LSAs are translated into Type 5 LSAs by NSSA ABRs, which are flooded throughout the whole
routing domain. Summarization and filtering are supported during the translation.
Use NSSA to simplify administration if you are a network administrator that must connect a central site using
OSPF to a remote site that is using a different routing protocol.
Before NSSA, the connection between the corporate site border router and remote router could not be run as
an OSPF stub area because routes for the remote site could not be redistributed into a stub area, and two
routing protocols needed to be maintained. A simple protocol like RIP was usually run and handled the
redistribution. With NSSA, you can extend OSPF to cover the remote connection by defining the area between
the corporate router and remote router as an NSSA. Area 0 cannot be an NSSA.
Routers
The OSPF network is composed of ABRs, ASBRs, and interior routers.
Area Border Routers
An area border routers (ABR) is a router with multiple interfaces that connect directly to networks in two or
more areas. An ABR runs a separate copy of the OSPF algorithm and maintains separate routing data for each
OL-30423-03
Figure 16: OSPF Routing Components, on page
336, Area 2 is a stub area that is reached only through ABR 2. Area 0
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OSPF Routing Components
336, Area 0 is an OSPF backbone
Figure 16:
337
Advertisement
Table of Contents
