Advertisement
Quick Links
13W LED WALLPACK INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your
comments. Call the us at 888-RAB-1000, or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.
Make certain power is OFF before installing or maintaining fixture. No user serviceable
WARNING:
parts inside.
JUNCTION BOX MOUNT FOR
CONDUIT
For use on applications where conduit wiring is
necessary.
1.
Loosen and remove (3) Lens Screws. Remove
Door.
2.
Loosen and remove (2) Housing Screws. Remove
Housing from Back Box. Keep Housing Gasket
intact for re-assembly.
3.
Secure Back Box to the mounting surface using
hardware appropriate for that mounting surface.
4.
Wire the fixture using UL listed wire connectors
according to NEC and local codes. Apply sealant to
all unused conduit entry points.
5.
Place Gasket between Back Box and Housing.
Re-mount Housing to Back Box. Check Housing
Gasket seal all around the Back Box.
6.
Re-mount Door to Housing. Tighten (3) Lens
Screws. Check door gasket(not shown) seal.
7.
Fixture can be mounted upside down in dry and
damp locations only.
Housing
Gasket
Back Box
Lens
Screws
Junction Box
SURFACE MOUNT FOR
RECESSED BOX
For use with recessed junction box and wiring.
1.
2.
3.
4.
5.
6.
Housing
Housing
Screws
Door
Surface Mount
Use supplied crossbar. Mount Crossbar to recessed
junction box with (2) screws.
Place Gasket on back of the fixture. Gasket should
create seal against mounting surface.
Wire fixture to supply wires in recessed box according
to wiring section.
Use 1/4 x 20 stainless steel Mounting Screw to
attach fixture to Crossbar. Tighten Mounting Screw.
Cover screw with Cap, provided.
Fixture can be mounted upside down in dry and damp
locations only.
Crossbar
Gasket
Recessed
Junction
Box (not
provided)
.
Cap
Mounting
Screw
Advertisement
Related Manuals for RAB WPLED13N
Summary of Contents for RAB WPLED13N
- Page 1 Junction Box Surface Mount Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call the us at 888-RAB-1000, or email: marketing@rabweb.com IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE.
-
Page 2: Troubleshooting
13W LED WALLPACK INSTALLATION INSTRUCTIONS JUNCTION BOX WIRING Universal voltage driver permits operation at 100 to 1. The Junction box has (4) conduit entry points 277VAC, 50 or 60Hz. on the center of each side and (1) in the center back.