Advertisement
Quick Links
LighlA/ert!.
Important!
TEST PERIOD LASTS FOR 5 MINUTES
AFTER POWER IS TURNED ON.
■
The Luminator has a 5 minute test period to allow a walk test
during daylight. During this five minute period the unit will turn
lights on for only 5 seconds each time it detects an object in its
Detection Zone.
■
After the 5 minute test period, the Luminator will reset itself
to ni g ht only operation.
■
For an additional 5 minute test period, turn power off for
10 seconds, then back on.
■
During darkness, lights will remain on, after motion ceases,
for the delay period set on the time control dial.
How Does Luminator Work?
Luminator's infrared sensor "sees"
small temperature changes caused
by the motion of people or cars with
in its detection zone and turns on
lights automatically. 11 welcomes
visitors and may deter intruders.
How long do the lights
stay on?
Lights turn off a short time after
motion in the detection zone stops.
You can adjust this time from
5 seconds up to 1 0 minutes. Since
the lights are only on when needed,
Luminator is ex1 r emely energy
efficient.
Can outdoor lights still be
turned on with the light
switch?
Yes. Luminator can be controlled
by a conventional indoor switch or
circuit breaker. Lights can be turned
on or off manually at night only.
■
Manual Override Mode (to
keep lights on): Flip the switch
"off"" then "on·· again two times
(off-on-off-on) within 2 seconds.
■
To Resume Automatic Mode:
Flip the switch once (off-on) within
2 seconds, sensor will reset to
Automatic Mode.
Will Luminator detect
animals?
Luminator may detect large animals.
Having animals trigger Luminator can
help give property a "lived-in" look.
You limit animal detection by turning
down the sensitivity knob or by
placing electrical tape on the lower
part of the lens, or both.
Masking
the lens
How are Time and
Sensitivity set?
Time and Sensitivity adjustments
are located on the underside of
the sensor. To adjust, tum the
knob with your fingers.
■
Time: sets the time from
5 seconds to 1 O minutes that
lights will remain on after
protection zone is vacated.
■
Sensitivity: increases or
decreases the responsiveness
of the sensor and its range.
Specifications:
Catalog#:
LS300 or
LU300
Switching Capacity:
300 watts
5Amps
Voltage:
120 volts
Protection Pattern:
50'x110
°
Time Adjustment:
5 seconds to
10 minutes
Lampholders
Maximum
one 150 watt
Par38 lamp
per lampholder
Misc. Fix1ures
Suitable for
Wet Locations
Advertisement
Related Manuals for RAB LUMINATOR LightAlert! LU300
Summary of Contents for RAB LUMINATOR LightAlert! LU300
- Page 1 LighlA/ert!. How Does Luminator Work? Luminator's infrared sensor "sees" small temperature changes caused by the motion of people or cars with Important! in its detection zone and turns on lights automatically. 11 welcomes TEST PERIOD LASTS FOR 5 MINUTES visitors and may deter intruders. Masking AFTER POWER IS TURNED ON.
-
Page 6: Limited Warranty
$1 5.00 (made c) Serial Number manently impaired by these signals. out to RAB Electric). We will repair d) This Installation Manual or replace your unit. 5. Check all the Solutions Under no circumstances shall we mentioned under "Lights Turn On...