Ipv6 Lisp Map-Request-Source - Cisco Nexus 7000 Series Command Reference Manual
Nx-os lisp command reference
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
ipv6 lisp map-request-source
To configure an IPv4 or IPv6 address to be used as the source address for Locator/ID Separation Protocol
(LISP) IPv6 Map-Request messages, use the ipv6 lisp map-request-source command. To remove the
configured Map-Request source address and return to the default behavior, use the no form of this
command.
Syntax Description
ource-address
The Cisco NX-OS device uses one of the locator addresses that you configure by using the ipv6 lisp
Defaults
database-mapping command as the default source address for LISP Map-Request messages.
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History
Release
5.0(1.13)
A locator address that you configured in by using the ipv6 lisp database-mapping command is used as
Usage Guidelines
the source address for LISP IPv6 Map-Request messages. There are cases, however, where it may be
necessary to configure the specified source address for these Map-Request messages. For example, when
the ingress tunnel router (ITR) is behind a Network Address Translation (NAT) device, you might need
to specify a source address that matches the NAT configuration to properly allow for return traffic.
When you enter the ipv6 lisp map-request-source command on an ITR, the specified IPv4 or IPv6
locator is used by an ITR as the source address for LISP IPv6 Map-Request messages. When you enter
the ipv6 lisp map-request-source command on a Map-Server, this locator is used as the source address
in the Encapsulated Control Message that carries a Map-Request to an ETR.
This command does not require a license.
This example shows how to configure an ITR to use the source IPv6 address in its IPv6 Map-Request
Examples
messages:
switch# configuration terminal
switch(config)# ipv6 lisp map-request-source 2001:DB8:0A::1
OL-25345-01
ipv6 lisp map-request-source source-address
no ipv6 lisp map-request-source source-address
IPv4 or IPv6 source address to be used in LISP IPv6 Map-Request messages.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ipv6 lisp map-request-source
LSP-109
Advertisement
Table of Contents
