Siemens SIMATIC S5 Manual page 4
Positioning module
1p 247
for stepper motors
Hide thumbs
Also See for SIMATIC S5:
- Manual (396 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
I
.
.
1 What is ESD?
VSLI chips (MOS technology) are used in practically all SIMATIC S5 and TELEPERM M mod-
ules. These VLSI components are, by their nature, very sensitive to overvottages and thus to
electrostatic discharge:
They are therefore defined as
"Electrostatically sensitive @vices"
The following warning label on the cabinets, subracks and packing indicates that electrostatically
sensitive components have been used and that the modules concerned are susceptible to touch:
human beings. Such voltages already occur when a component or a module is touched by a
person who has not been electrostatically discharged. Components which have been subjected
to such overvoltage cannot, in most cases, be immediately detected as faulty; the fault occurs
only after a long period in operation.
An electrostatic discharge
- of 3500 V can be felt
of 4500 V can be heard
must take place at a minimum of 5000 V to be seen.
But just a fraction of this voltage can already damage or destroy an electronic component.
The typical data of a component can suffer due to damage, overstressing or weakening caused
by electrostatic discharge; this can result in temporary fault behavior, e.g. in the case of
- temperature variations,
mechanical shocks,
vibrations,
- change of load.
Only the consequent use of protective equipment and careful observance of the precautions for
handling such components can effectively prevent functional disturbances and failures of ESD
modules.
Guidelines for Handling
Electrostatically Sensitive Devices (ESD)
Advertisement
Table of Contents
