Cleaning; Functional Inspection - Husqvarna K760 Operator's Manual
Cut-n-break
Hide thumbs
Also See for K760:
- Operator's manual (124 pages) ,
- Workshop manual (61 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Available languages
Available languages
Cleaning
External cleaning
•
Clean the machine daily by rinsing it with clean water
after the work is finished.
Cooling air intake
•
Clean the cooling air intake when needed.
NOTICE! A dirty or blocked air intake results in the
machine overheating which causes damage to the
piston and cylinder.
Spark plug
•
If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
•
Ensure that the spark plug cap and ignition lead are
undamaged to avoid the risk of electric shock.
•
If the spark plug is dirty, clean it and at the same time
check that the electrode gap is 0.5 mm. Replace if
necessary.
NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
These factors cause deposits on the spark plug
electrodes, which may result in operating problems and
starting difficulties.
•
An incorrect fuel mixture (too much or incorrect type
of oil).
•
A dirty air filter.
20 – English
MAINTENANCE
Functional inspection
General inspection
•
Check that nuts and screws are tight.
Cutting blades
Replacing the blades
The blades have integrated belt pulley halves and are to
be changed in pairs.
•
Loosen the bar nuts one turn anticlockwise.
•
Screw the belt adjuster a few turns anticlockwise.
•
This will position the drive belt in a more favourable
position with regard to assembling the new blades.
The drive belt is not clamped so easily.
•
Dismantle the old blades by loosening the centre nut.
•
Check the drive belt for wear. See instructions under
the heading "Drive belt".
- Quick Links:
- Before Starting
Hide quick links:
Advertisement
Chapters
Table of Contents
