Table of Contents
Advertisement
Windows 2000 Installation Sequence
If a Windows operating system is already installed or if the programming device
has been started with a bootdisk, the transfer of the data takes place using the
program OEMSETUP.EXE. To do this, start the program OEMSETUP.EXE on the
recovery CD and continue the sequence as of point 5.
If there is no operating system installed, then please do the following:
1. Insert the CD "Recovery Microsoft Windows 2000" in the CD-ROM drive and
turn on the programming device.
2. To boot from CD "Recovery Microsoft Windows 2000", press the ESC key at the
BIOS message:
Press <F2> to enter Setup.
After completing the initalization a boot menu screen appears in which you can
select the device to be booted from.
3. Select "ATAPI CD-ROM Drive".
4. Select "1. Boot for CD-Recovery" in the screen "Microsoft Windows 98 Startup
Menu".
5. You have to acknowledge the "SIEMENS End User License Agreement" with
the F8 function key. Pressing ESC allows you to decline the agreement and
cancels the installation.
6. In the next screens you can select the components which are to be copied from
the CD to the hard disk. At the very least it is necessary to copy the folder
"I386" to install or setup Windows 2000.
7. A selection of disk drives for the data transfer is next offered. The disk drive
selected is not the installation drive for Windows. It is the drive on which the
necessary installation files and extensions are saved. You need approximately
500 MB of additional memory for the Windows setup following the transfer.
During a standard installation Windows 2000 is installed on drive C:. Therefore,
please make sure when selecting a drive that there is enough available memory
on drive C: after the data transfer.
8. You can start the Windows setup after the data transfer and acknowledgment of
the completion message via the program
HD:\I386\Winnt.exe
(HD: drive on which the folder I368 was transferred to).
If a Windows operating system already installed, you can start the Windows
2000 setup after starting Windows via the program
HD:\I368\Winnt32.exe.
You can find information on installing Windows 2000 in the manual "Microsoft
Windows 2000 Professional". Follow the instructions in the section "Setting Up
Windows 2000 Professional".
Operating Instructions PG 740 PIII
A5E00063150-03
Siemens Drives & PLCs
Reinstallation of the Software
6-13
- Quick Links:
- Overview
Hide quick links:
Advertisement
Table of Contents
