Table of Contents
Advertisement
Windows 98 Installation Sequence
If a Windows operating system is already installed or if the programming device
has been started with a bootdisk, the transfer of the data takes place using the
program OEMSETUP.EXE. To do this, start the program OEMSETUP.EXE on the
recovery CD and continue the sequence as of point 5.
If there is no operating system installed, then please do the following:
1. Insert the Recovery CD-ROM Microsoft Windows 98 in the CD-ROM drive and
switch on the PLC.
2. To boot from the recovery CD proceed as follows: When the message
Press <F2> to enter Setup
appears on the screen press the ESC key. After intialization a boot menu to
select the boot options is displayed.
3. Select "4. ATAPI CD-ROM Drive".
4. When "Microsoft Windows 98 Startup Menu" is displayed, select
"1. Boot for CD-Recovery".
5. You have to acknowledge the "SIEMENS End User License Agreement" with
the F8 function key. Pressing ESC allows you to decline the agreement and
cancels the installation.
6. In the next screens you can select the components which are to be copied from
the CD to the hard disk. Transfer of at least the folder "WIN98" is necessary for
the Windows98 installation or setup.
7. A selection of disk drives for the data transfer is next offered. The disk drive
selected is not the installation drive for Windows. It is the drive on which the
necessary installation files and extensions are saved. You need approximately
250 MB of additional memory for the Windows setup following the transfer.
During a standard installation Windows 2000 is installed on drive C:. Therefore,
please make sure when selecting a drive that there is enough available memory
on drive C: after the data transfer.
8. You can start the Windows98 setup after the data transfer and
acknowledgement of the completion message via the program
HD:\WIN98\SETUP.EXE
(HD: drive on which the folder WIN98 was transferred to).
For further information on the installation of Windows 98 refer to Chapter 2
"Installing Windows 98" of the "Getting Started Microsoft Windows 98" manual.
Follow the instructions given in section "Performing a New Installation".
Operating Instructions PG 740 PIII
A5E00063150-03
Siemens Drives & PLCs
Reinstallation of the Software
6-7
- Quick Links:
- Overview
Hide quick links:
Advertisement
Table of Contents
