Call Detail Report Filter; Call Detail Report Through Serial; Interface - Siemens HiPath 1100 Programming Manual
Analog mf telephones
Hide thumbs
Also See for HiPath 1100:
- Service manual (389 pages) ,
- Programming manual (241 pages) ,
- User manual (137 pages)
Table of Contents
Advertisement
Step by Step
Wait 5 seconds
*
= Outgoing calls are recorded at the end of the call.
4
Initial state for Programming Mode.
Call Detail Report Filter
The number programmed in this filter specifies the type
of outgoing call to be recorded, based on the first four
digits of the dialed number.
For example, in order to record only international outgo-
ing calls, you must program the digits "00."
The maximum number of digits is 4.
In the default setting a digit sequence is not configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 7
Enter the sequence of digits (up to 4) for the numbers
to be recorded.
Wait for a confirmation tone.
Initial state for Programming Mode.
Call Detail Report through Serial
Interface
This setting specifies if Call Detail Report will be done
through a serial interface or a modem.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0
0 6
or
Activate/Deactivate Call Detail Report through a serial
#
interface:
= To activate
*
= To deactivate (default)
#
Initial state for Programming Mode.
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Caller ID service must be contracted with a local
carrier.
Call Detail Report Manager
127
- Quick Links:
- Programming Mode
Hide quick links:
Advertisement
Table of Contents
