Number Of Attempts For Activating The Sensor; Dtmf Signals For The Relay - Siemens HiPath 1100 Programming Manual
Analog mf telephones
Hide thumbs
Also See for HiPath 1100:
- Service manual (389 pages) ,
- Programming manual (241 pages) ,
- User manual (137 pages)
Table of Contents
Advertisement
Relay and Sensor on the HiPath 1120
Step by Step
...
0
0 1
168
Number of Attempts for Activating the Sensor
This setting specifies the number of call attempts (be-
tween 1 and 100) for the number specified in "Number
Dialed by Sensor Activation." (See also Time between
Attempts for Activating the Sensor).
An attempt is made after every call that was not an-
swered (busy signal), or when the "Detect DTMF Code"
option (Code 70, Option 3) is enabled and no acknowl-
edgment is received. When this occurs, the call is dis-
connected and a new attempt is made.
By default, only one attempt is made.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 3
Enter the number of attempts (001 to 100).
1
0 0
Initial state for Programming Mode.
DTMF signals for the Relay
This setting specifies a number sequence that is con-
verted to DTMF signals and sent after a call is an-
swered. The number to be called must be specified in
"Number Dialed by Sensor Activation" (Code 052).
The default configuration does not specify any number.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1
7 7
Enter the number sequence (up to 20 digits).
Press this key.
#
Initial state for Programming Mode.
- Quick Links:
- Programming Mode
Hide quick links:
Advertisement
Table of Contents
