Table of Contents
Advertisement
4. STARTUP
4.1 Switching power on for the first time
When switching power on for the first time, follow this section to make a startup.
4.1.1 Startup procedure
Wiring check
Surrounding environment check
Axis No. settings
Parameter setting
Test operation of the servo motor
alone in test operation mode
Test operation of the servo
motor alone by commands
Test operation with the servo
motor and machine connected
Gain adjustment
Actual operation
Stop
Check whether the servo amplifier and servo motor are wired correctly using
visual inspection, DO forced output function ("MR-J4-_B_(-RJ) Servo
Amplifier Instruction Manual" section 4.5.1), etc. (Refer to section 4.1.2.)
Check the surrounding environment of the servo amplifier and servo motor.
(Refer to section 4.1.3.)
Set a station No. with the auxiliary station number setting switches (SW2-3,
SW2-4) and station number setting rotary switch (SW1). (Refer to section
4.2.1 (2).)
Set the parameters as necessary, such as the used operation mode and
regenerative option selection. (Refer to chapter 5.)
For the test operation, with the servo motor disconnected from the machine
and operated at the speed as low as possible, check whether the servo
motor rotates correctly. (Refer to "MR-J4-_B_(-RJ) Servo Amplifier
Instruction Manual" section 4.5.)
For the test operation with the servo motor disconnected from the machine
and operated at the speed as low as possible, give commands to the servo
amplifier and check whether the servo motor rotates correctly.
After connecting the servo motor with the machine, check machine motions
with sending operation commands from the controller.
Make gain adjustment to optimize the machine motions. (Refer to "MR-J4-
_B(-RJ) Servo Amplifier Instruction Manual" chapter 6.)
Stop giving commands and stop operation.
4 - 2
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
