Network Module Port Configurations; C9300-Nm-2Q Module - Cisco Catalyst 9300 Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst 9300 Series:
- Hardware installation manual (140 pages) ,
- Installing (22 pages) ,
- Manual (15 pages)
Table of Contents
Advertisement
Network Module Port Configurations
Caution
Caution
Caution
Step 4
Position the module face up to install it in the module slot. Slide the module into the slot until the screw makes
contact with the chassis. Fasten the captive screws to secure the network module in place.
Figure 30: Installing the Network Module in the Switch
Network Module Port Configurations
C9300-NM-2Q Module
If you use a 40G QSFP module, the ports default to 40G interfaces. In this case, the 10G interfaces are displayed
but not used.
Table 19: C9300-NM-2Q Module with 40G QSFP Module
Interface
FortyGigabitEthernet1/1/1
FortyGigabitEthernet1/1/2
TenGigabitEthernet1/1/1
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
54
Verify the correct orientation of your module before installing it. Incorrect installation can damage
the module.
Do not install the network module with connected cables or installed pluggable transceivers. Always
remove any cables and transceiver modules before you install the network module.
A module interface might become error-disabled when a network module with connected fiber-optic
cables is installed or removed. If an interface is error-disabled, you can reenable the interface by
using the shutdown and no shutdown interface configuration commands.
Action
Configure this interface
Configure this interface
Disregard
Installing a Network Module
- Quick Links:
- Switch Models
- Front Panel Components
Hide quick links:
Advertisement
Table of Contents
