Install and Remove PVDM4 on Cisco 4400 or 4300 Series ISRs
Check that the SM-X is installed correctly on the system board.
Step 6
For more details on installation of SM-Xs, NIMs, and Cisco E-Series Server Modules, see the hardware
Note
installation guide for the particular module you have purchased.
For a list of links to all the SM-Xs and NIMs supported on your router, see the
for the Cisco 4000 Series
Verify SM-X Installation
Use the show diag command to verify that the SM-X is installed correctly. In the following example,
one SM-X is recognized by the system.
router#show diag ?
all
chassis
slot
subslot
Router#show diag subslot 2/0 eeprom detail
SPA EEPROM data for subslot 2/0:
Install and Remove PVDM4 on Cisco 4400 or 4300 Series ISRs
This section describes the installation tasks for the PVDM4 used on the router. The tasks that you
perform for installing and removing the PVDM4 are based on specific models of the Cisco 4000 Series
Integrated Service Routers.
See the relevant sub-section to install and remove PVDM4 for your specific router in the Cisco 4000
Series ISRs:
•
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-32
ISRs.
All related information
Chassis related information
Slot location information for this command
Subslot location information for this command
EEPROM version
Compatible Type
Controller Type
Hardware Revision
PCB Part Number
Top Assy. Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
Asset ID
Product Identifier (PID) : SM-X-1T3/E3
Version Identifier (VID) : V01
CLEI Code
Base MAC Address
MAC Address block size
Manufacturing Test Data
Environment Monitor Data : 40 0B E3 43 00 0A
Platform features
Tools and Equipment Requirements
Chapter 5
: 4
: 0xFF
: 1909
: 1.0
: 73-14154-02
: 800-36532-01
: 06
: 123598
: 02
: FOC15495HU1
: REV 2F
: TBD
: C4 0A CB 56 00 99
: 3
: 00 00 00 00 00 00 00 00
: 02 01 01 0A 00 00 00 00
01 01 00
Install and Upgrade Internal Modules and FRUs
Documentation Roadmap
OL-32185-02