Replace Cover On Cisco 4300 Isr; Locate Internal And External Slots - Cisco 4000 Series Hardware Installation Manual
Integrated services routers
Hide thumbs
Also See for 4000 Series:
- Upgrade manual (24 pages) ,
- Installation manual (18 pages) ,
- Manual (52 pages)
Table of Contents
Advertisement
Locate Internal and External Slots
Figure 5-1
1
Replace Cover on Cisco 4300 ISR
To replace the cover:
Read the
Step 1
Confirm the router is turned off and disconnected from the power supply or power supplies. If a
Step 2
redundant power is used disconnect from the redundant power supply.
Place the chassis on a flat surface.
Step 3
Hold the cover at a 45-degree angle and insert the cover tabs into the slots along the front (bezel) edge
Step 4
of the chassis. See
Step 5
Center the cover over the chassis and lower it onto the chassis.
Install the four cover screws on the top of the router and the two cover screws at the side of the router.
Step 6
Locate Internal and External Slots
Cisco 4400 Series ISRs and Cisco 4300 Series ISRs have replaceable internal modules.
Cisco 4200 Series ISR do not have any replaceable internal modules.
Note
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-6
Install the Cover on the Router (Shown Cisco 4451-X ISR )
Cover screws (3)
Safety Warnings, page 5-2
Figure
5-1.
Chapter 5
1
and disconnect the power supply before you replace any module.
Install and Upgrade Internal Modules and FRUs
OL-32185-02
Hide quick links:
Advertisement
Table of Contents
