Install The Pvdm4 On Cisco Fourth-Generation T1/E1 Voice And Wan Nim - Cisco 4000 Series Hardware Installation Manual
Integrated services routers
Hide thumbs
Also See for 4000 Series:
- Upgrade manual (24 pages) ,
- Installation manual (18 pages) ,
- Manual (52 pages)
Table of Contents
Advertisement
Install and Remove PVDM4 on Cisco 4400 or 4300 Series ISRs
Install the PVDM4 on Cisco Fourth-Generation T1/E1 Voice and WAN NIM
Shut down the electrical power to the slot in the router by either turning off the electrical power to the
Step 1
router or by issuing the online insertion and removal (OIR) commands. Leave the power cable plugged
in to channel ESD voltages to ground. For more information on OIR, see the Appendix, "Online
Insertion and Removal (OIR) and Hot-Swapping".
Loosen the two captive screws on the network interface module.
Step 2
Remove the network interface module. (See
Step 3
Figure 5-29
1
Locate the three standoffs on the network interface module where the PVDM4 resides.
Step 4
Align the PVDM4 with the connector and the standoffs, and attach the PVDM4 with the three screws.
Step 5
Slide the network interface module back in the router, and tighten the captive screws.
Step 6
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-38
Network Interface Module with PVDM4
Captive Screws
Chapter 5
Install and Upgrade Internal Modules and FRUs
Figure
5-29.)
1
OL-32185-02
Hide quick links:
Advertisement
Table of Contents
