10-Gigabit Ethernet Module Slots; Leds - Cisco Catalyst Blade Switch 3130 Hardware Installation Manual
For dell
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Reference manual (984 pages) ,
- Installation manual (29 pages)
Table of Contents
Advertisement
Other Features
10-Gigabit Ethernet Module Slots
The switch 10-Gigabit Ethernet module slots are used for uplink connections to other switches and
routers. The module slots operate in full-duplex mode and use the Cisco TwinGig Converter Module.
The CBS 3130X-S uses the hot-swappable Cisco X2 transceiver modules and the Cisco TwinGig
Converter Module. The CBS 3130X-S supports these X2 transceiver modules:
•
•
•
For more information about the 10-Gigabit Ethernet module slots, see the
10-Gigabit Ethernet Slots" section on page
and Cable Specifications."
The Cisco Catalyst Blade Switch 3032G and 3130G support only the Cisco TwinGig Converter Modules,
not the X2 transceiver modules.
Cisco TwinGig Converter Module
The Cisco TwinGig Converter Module (model CVR-X2-SFP), also known as the converter module, has
two small form-factor pluggable (SFP) module slots that convert the 10-Gigabit slot into a dual
SFP module interface to establish Gigabit uplinks to network devices. The SFP modules have
LC connectors for fiber-optic connections or RJ-45 connectors for copper connections.
These are the supported Cisco SFP modules:
•
•
•
For more information about the Cisco TwinGig Converter Module, see the
Modules and Cisco Converter Modules" section on page 2-22
Modules and Cisco Converter Modules" section on page
"Connector and Cable Specifications."
LEDs
You can use the switch LEDs to monitor switch activity and performance. The System LEDs are
controlled by the Cisco IOS software. The System Status ID/LED is controlled by the Dell software. For
graphical representations of the LEDs described in this section, see the device manager GUI.
The LEDs are described in these sections:
•
•
•
•
•
•
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
1-4
CX4
LRM
SR
1000BASE-LX/LH SFP (GLC-LH-SM)
1000BASE-SX (GLC-SX-MM)
1000BASE-T SFP (GLC-T)
System LED, page 1-5
Stack LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-5
Stack Master LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-5
Stack Member LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-6
RJ-45 Uplink Port LEDs, page 1-6
System Status/ID LED, page 1-6
2-21. For cable specifications, see
and the
2-22. For cable specifications, see
Chapter 1
Product Overview
"Installing Devices in the
Appendix B, "Connector
"Installing X2 Transceiver
"Installing X2 Transceiver
Appendix B,
OL-13269-01
Advertisement
Table of Contents
