Cisco Catalyst Blade Switch 3130 Hardware Installation Manual page 32
For dell
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Reference manual (984 pages) ,
- Installation manual (29 pages)
Table of Contents
Advertisement
Configuring the Switch
You have now completed the initial configuration of the switch, and the switch displays its initial
configuration. An example of the output is shown here:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0
enable password enable_password
line vty 0 15
password terminal-password
snmp-server community public
!
!
interface Vlan1
no shutdown
ip address 10.0.0.1 255.255.255.0
!
interface FastEthernet0
shutdown
no ip address
!
interface GigabitEthernet1/0/1
!
interface GigabitEthernet1/0/2
!
. . . (output truncated)
!
interface TenGigabitEthernet1/0/1
!
interface TenGigabitEthernet1/0/2
!
end
Step 10
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Disconnect the server chassis serial port or the switch console port from the PC. See the
Step 11
Switch" section on page 2-15
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
2-12
for information about configuring and managing the switch.
Chapter 2
Switch Installation
"Managing the
OL-13269-01
Advertisement
Table of Contents
