Cisco Catalyst Blade Switch 3130 Hardware Installation Manual page 34
For dell
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Reference manual (984 pages) ,
- Installation manual (29 pages)
Table of Contents
Advertisement
Configuring the Switch
You can enter the Optional Settings information now or enter it later by using the device manager
interface.
Figure 2-6
In the Host Name field, enter a name for the switch module. The host name is limited to 31 characters;
Step 3
embedded spaces are not allowed.
In the System Date and System Time fields, enter the current date and time, or use the down arrows to
Step 4
select them.
In the Time Zone field, use the down arrow to choose your time zone.
Step 5
Click Enable in the Daylight Savings Time field to enable this feature.
Step 6
In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch module by
Step 7
using the CLI. If you enable Telnet access, you must enter a Telnet password.
Note
In the Telnet Password field, enter a password. The Telnet password can be from 1 to 25 alphanumeric
Step 8
characters, is case sensitive, allows embedded spaces, but does not allow spaces at the beginning or end.
In the Confirm Telnet Password field, re-enter the Telnet password.
In the SNMP field, click Enable to enable Simple Network Management Protocol (SNMP). Enable
Step 9
SNMP only if you plan to manage switches by using CiscoWorks 2000 or another SNMP-based
network-management system.
If you enable SNMP, you must enter a community string in the SNMP Read Community field, the
Step 10
SNMP Write Community field, or both. SNMP community strings authenticate access to MIB objects.
Embedded spaces are not allowed in SNMP community strings. When you set the SNMP read
community, you can access SNMP information, but you cannot change it. When you set the SNMP write
community, you can both access and change SNMP information.
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
2-14
Advanced Settings Tab
If you plan to create a switch stack, enable Telnet access so that you can use the CLI to set this
switch to the highest priority (usually 15). See the
3130G-S and 3130X-S Switches)" section on page 2-17
switch stack.
Chapter 2
"Planning and Creating a Switch Stack (Only
for more information about creating a
Switch Installation
OL-13269-01
Advertisement
Table of Contents
