Table of Contents
Advertisement
CHAPTER 2 PROGRAMMING MODE
FIGURE 2-1
2 - 1
Use Programming Mode to configure the instrument.
2.1 Entering and Exiting Programming Mode
☛ To enter Programming Mode
1.
Do one of the following:
• Hold the '8' key down for five seconds.
After using this method, you cannot alter certain parameters for
W&M.
• Use the switch on the instrument.
On the Model 1010 the switch is located on the right hand side of
the enclosure. This switch may be fitted with a tamper seal for
W&M requirements.
Model 1010A instrument switch
If the instrument is not idle (for example, the instrument is in use by
an operator, or a vehicle overfill or earth system is connected) it
displays the following:
• In this case, either disconnect the permissives to bring the
instrument to the idle state, or wait until loading is complete and
then enter your password.
If password mode is available the instrument displays the following:
2.
Enter a valid setup password.
Model 1010 Application Pack CB
Programming Manual
PASSWORD MODE
PASSWORD MODE
NOT AVAILABLE
NOT AVAILABLE
ENTER PASSWORD (XXXX)
ENTER PASSWORD (XXXX)
>
>
Part No.: 4418024 - Rev. 1
Hide quick links:
Advertisement
Table of Contents
