Table of Contents
Advertisement
Maintaining the Server
• The server BIOS includes a configuration utility specific to this controller that you can use to create and
Replacing a Cisco Boot-Optimized M.2 RAID Controller
This topic describes how to remove and replace a Cisco Boot-Optimized M.2 RAID Controller. The controller
board has one M.2 socket on its top (Slot 1) and one M.2 socket on its underside (Slot 2).
Step 1
Shut down and remove power from the server as described in
page
7.
Step 2
Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach
cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Caution
Step 3
Remove the top cover from the server as described in
Step 4
Remove a controller from its motherboard socket:
a) Locate the controller in its socket just in front of power supply 1.
b) At each end of the controller board, push outward on the clip that secures the carrier.
c) Lift both ends of the controller to disengage it from the socket on the motherboard.
d) Set the carrier on an anti-static surface.
Figure 37: Cisco Boot-Optimized M.2 RAID Controller on Motherboard
Location of socket on motherboard
1
delete RAID volumes, view controller properties, and erase the physical drive contents. Access the utility
by pressing F2 when prompted during server boot. Then navigate to Advanced > Cisco Boot Optimized
M.2 RAID Controller.
Replacing a Cisco Boot-Optimized M.2 RAID Controller
Shutting Down and Removing Power From the Server, on
Removing the Server Top Cover, on page
Securing clips
3
9.
Maintaining the Server
67
- Quick Links:
- Rear Panel Leds
- Replacing Fan Modules
Hide quick links:
Advertisement
Table of Contents
