Mitsubishi Electric RFID ECL2-V680D1 User Manual page 5

Interface module

Table of Contents

 After product use begins, be sure the number of times the terminal block is installed and removed

does not exceed 50 (JIS B 3502 compliant). Exceeding 50 results in the risk of malfunction.

 Be sure to shut off all phases of the external power supply used in the system before cleaning or

tightening terminal screws or module screws. Failure to do so results in the risk of module failure

and malfunction. If a screw is too loose, a dropped module, short circuit, or malfunction may

result. If a screw is too tight, screw and/or module damage may occur, resulting in a dropped

module, short circuit, or malfunction.

 The module case is made of plastic. Do not drop the case or expose the case to strong impact.

Doing so results in the risk of module damage.

 Before touching the module, be sure to touch grounded metal or the like to release the static

electricity from your body. Failure to do so results in the risk of module failure or malfunction.

 When cleaning, do not use thinner, benzene, acetone, or kerosene. Doing so results in the risk of

module damage.

 Do not insert water or wire through the gaps in the case. Doing so results in the risk of fire or

electric shock.

 This product cannot be used as a detector for physical protection. Erroneous output or

malfunction may result in an accident.

 When installing or removing the antenna from the amplifier, first turn OFF the module power

supply. Failure to do so results in the risk of module failure and malfunction.

 Installation of multiple antennas may result in a decrease in communication performance due to

mutual interference. Refer to the description of mutual interference between antennas in the

antenna user's manual.

 In the unlikely event that you feel something is wrong with the product, stop using the product

immediately, turn OFF the power supply, and consult with your local Mitsubishi service center or

representative. Continued use as is results in the risk of module failure and malfunction.

 Do not use the product in locations where chemical products and oil are scattered. Doing so

results in the risk of module failure and malfunction.

 When using the product, be sure to observe the defined ambient temperature and humidity.

Failure to do so results in the risk of module failure and malfunction.

 Do not touch any connectors when the module is powered. Doing so results in the risk of module

malfunction caused by the static electricity in your body.

[DISPOSAL PRECAUTIONS]

 At the time of disposal, treat the product as industrial waste.

A - 4

CAUTION

A - 4

Table of Contents