Siemens ST950 Handbook page 81
Hide thumbs
Also See for ST950:
- User manual (178 pages) ,
- Handbook (154 pages) ,
- Installation method statement (14 pages)
Table of Contents
Advertisement
The aspect to be tested is identified and the following information entered into the
web page:
•
Phase
•
Aspect Colour
•
Duration of Test in seconds
•
Once this information has been entered, press the 'Submit' and 'Confirm'
buttons to start the test. The remaining time for the test is displayed against
'Progress'.
•
The RS232 Handset 'LMP' command can also be used for lamp testing.
7.5.12 Learning Lamp Loads
When a new configuration is loaded or lamp loads are added or removed the lamp
monitoring system will need to learn the connected loads. This can be achieved
through Level 3 access and the web page:
Status and Configuration → Controller → LMU → Reset
If red lamp faults have extinguished phases, always attempt a 'Red Lamp Fail Reset
Request' before attempting a 'Full Lamp Monitor Reset Request'.
Select the appropriate action and select 'reset' and then press the 'Submit' then
'Confirm' buttons.
To help with the learning sequence, artificial demands can be inserted along with a
forced Dim/Bright change to ensure that all loads are learnt.
The 'Learning Assist' feature can be enabled from the web page:
Status and Configuration → Controller → LMU → Reset/Learning
During the learning sequence, the percentage complete status for each signal can
be monitored on the web page:
Status and Configuration → Controller → LMU → Readings
The RS232 handset can also be used to learn the lamp loads using the handset
commands 'KRD' and 'KLR'.
7.5.13 Solar Cell Testing
Security classification
Version
Last Editor
Document Name
Copyright © Siemens Mobility Limited 2018. All Rights Reserved.
Use with Care!
All aspects under test must be covered
Use with Care!
Dim signals may be difficult for road users to see during daylight hours
Inserting artificial demands may confuse road users
For this test to be performed the ambient light conditions must be
sufficient to set the bright condition on the controller.
Unrestricted
5
Neil Atkinson
ST950 ICM Handbook
Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Page
81 of 125
Status
Issued
Date
18-Dec-2018
Document No.
667/HE/46950/000
- Quick Links:
- Fault Finding Starting from the Fault...
Hide quick links:
Advertisement
Table of Contents
