Advertisement
Add Managed Devices to the FMC
Step 4
Type a Job Name, and next to Update Items, check the Vulnerability Database check box.
Step 5
Click Save.
Step 6
Select System > Tools > Scheduling, then click Add Task.
Step 7
From the Job Type list, select Install Latest Update.
Step 8
Specify that you want to schedule a Recurring task, and establish a weekly schedule choosing appropriate
values for the Start On, Repeat Every, Run At and Repeat On fields.
Step 9
Type a Job Name, and next to Update Items, check the Vulnerability Database check box.
Step 10
Click Save.
Add Managed Devices to the FMC
For each managed device, use these instructions to establish a simple deployment that does not incude
multi-tenancy, clusters, or high availability. To configure a deployment using any of these features, see the
Firepower Management Center Configuration Guide
Before you begin
• Perform the device-specific setup activities and configure the device for remote management as described
• If your environment uses NAT, make note of the NAT ID used during device setup.
• If your environment uses DNS, note the hostname that resolves to a valid IP address for the device. If
• If your environment does not use DNS, you need the IP address for the device.
• Determine what license(s) are needed for the managed device and add them to the FMC; you will add
• You must assign an access control policy to the managed device in the course of adding it to the FMC.
Procedure
Step 1
Choose Devices > Device Management > Add > Add Device.
Step 2
In the Host field, enter the IP address or the hostname of the device to add.
The hostname of the device is the fully qualified name or the name that resolves through the local DNS to a
valid IP address. Use a hostname rather than an IP address if your network uses DHCP to assign IP addresses.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
38
in the
Getting Started Guide
Important
Be sure to note the registration key you use for the device.
your environment uses DHCP to assign IP addresses, use a host name to identify the device rather than
an IP address.
the license(s) to the managed device during the process of adding it to the FMC. See
Licensing, on page 30
and
Configure Classic Licensing, on page
The instructions below include a procedure to establish a basic access control policy for this purpose.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
for your version.
for that device.
Configure Smart
33.
Advertisement
