Advertisement
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
• If you choose to configure IPv4 manually, the system prompts for IPv4 address, netmask, and default
gateway. If you choose DHCP, the system uses DHCP to assign these values. If you choose not to use
DHCP, you must supply values for these fields; use standard dotted decimal notation.
• Configuring a DNS server is optional; to specify no DNS server enter none. Otherwise specify IPv4
addresses for one or two DNS servers. If you specify two addresses, separate them with a comma. (If
you specify more than two DNS servers, the system ignores the additional entries.) If your FMC does
not have internet access you cannot use a DNS outside of your local network.
Note
• You must enter the fully qualified domain name or IP address for at least one NTP server reachable from
your network. (You may not specify FQDNs for NTP servers if you are not using DHCP.) You may
specify two servers (a primary and a secondary); separate their information with a comma. (If you specify
more than two DNS servers, the system ignores the additional entries.) If your FMC does not have internet
access you cannot use an NTP server outside of your local network.
Example:
Enter a hostname or fully qualified domain name for this system [firepower]: fmc
Configure IPv4 via DHCP or manually? (dhcp/manual) [DHCP]: manual
Enter an IPv4 address for the management interface [192.168.45.45]: 10.10.0.66
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.224
Enter the IPv4 default gateway for the management interface [ ]: 10.10.0.65
Enter a comma-separated list of DNS servers or 'none' [CiscoUmbrella]:
208.67.222.222,208.67.220.220
Enter a comma-separated list of NTP servers [0.sourcefire.pool.ntp.org,
1.sourcefire.pool.ntp.org]:
Step 6
The system displays a summary of your configuration selections. Review the settings you have entered.
Example:
Hostname:
IPv4 configured via:
Management interface IPv4 address:
Management interface IPv4 netmask:
Management interface IPv4 gateway:
DNS servers:
NTP servers:
Step 7
The final prompt gives you the opportunity to confirm the settings.
• If the settings are correct, enter y and press Enter to accept the settings and continue.
• If the settings are incorrect, enter n and press Enter. The system prompts for the information again,
beginning with hostname.
Example:
Are these settings correct? (y/n) y
If your networking information has changed, you will need to reconnect.
Updated network configuration.
If you are using an evaluation license, specifying DNS is optional at this time, but DNS is
required to use permanent licenses for your deployment.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
FMC Initial Setup Using the CLI for Versions 6.5 and Later
fmc
manual configuration
10.10.0.66
255.255.255.224
10.10.0.65
208.67.222.222,208.67.220.220
0.sourcefire.pool.ntp.org, 1.sourcefire.pool.ntp.org
17
Advertisement
Related Manuals for Cisco Firepower Management Center 1600
Related Products for Cisco Firepower Management Center 1600
- Cisco FMC 1600
- Cisco FMC 2600
- Cisco FMC 4600
- Cisco FPR1010-ASA-K9
- Cisco Firepower Management Center 1500
- Cisco Firepower Management Center 1000
- Cisco Firepower 1010 Series
- Cisco Firepower 7010, Firepower 7020, Firepower 7030, Firepower 7050, Firepower 7110, Firepower 7120, Firepower 7115, Firepower 7125,