Table of Contents
Advertisement
Figure 18. Removing the chassis
Installing the library chassis
To install the chassis, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the library is turned off and that the power cord is disconnected.
3. Attach the back mounting brackets to the library.
4. Place the library chassis in the rack.
5. Install the screws that secure the mounting rails to the library chassis.
6. Install the screws that secure the mounting clamps to the back of the library
7. Install the tape drives. See "Installing a tape drive" on page 47 for more
8. Install the power supplies. See "Installing a power supply" on page 46 for more
9. Install the magazines. See "Installing a magazine" on page 47 for more
Removing the library controller
To remove the library controller, complete the following steps:
44
Universal Tape Library User's Guide
Power supplies
Left magazine
on page 7.
chassis.
information.
information.
information.
Tape
drives
Back mounting bracket
Advertisement
Table of Contents
