Table of Contents
Advertisement
10.4
Repair
Bosch Rexroth has an extensive service offer regarding repairs. Should you
have any queries, please contact Bosch Rexroth Service, see ⮫ Chapter 16.1
"Service and support" on page 77
10.5
Spare parts
Regarding spare parts, please contact Bosch Rexroth Service for clarification,
see ⮫ Chapter 16.1 "Service and support" on page 77. In addition, observe
the safety instructions in these operating instructions when working on the
servo-hydraulic actuator and the drive controller.
10.6
Replacement of components
For the replacement of defective components and in case of questions or when
in doubt, please contact Bosch Rexroth Service, see ⮫ Chapter 16.1 "Service
and support" on page 77.
RE62270-B, 01.21
Improper repair!
WARNING
−
For repairs the servo-hydraulic actuator may only be
disassembled to the extent described in these oper-
ating instructions.
−
Defective parts may only be replaced by new, inter-
changeable, tested components in original equipment
quality.
−
Only use genuine spare parts from Bosch Rexroth for
repairing the servo-hydraulic actuator and the drive
controller.
−
Repairs may only be performed by authorized, skilled
and instructed staff.
Danger due to pressurized servo-hydraulic actuator! Risk
WARNING
of injury! Severe injury when working on systems that
have not been shut down! Damage to property! Even
after the servo-hydraulic actuator was disconnected from
the electrical power supply, the system is still under
pressure and is permanently prestressed!
−
Observe the specifications of the system manufac-
turer and the system end-user.
−
Do not disconnect line connections, ports or compo-
nents as long as the servo-hydraulic actuator is pres-
surized.
−
The hydraulic circuit may only be opened by specifi-
cally trained personnel.
Servo-hydraulic actuator
Replacement of components
Bosch Rexroth AG
65 / 85
Advertisement
Table of Contents
