Configuring The System Using System Configuration Dialog - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual
Cisco systems universal broadband router hardware installation guide
Hide thumbs
Also See for Universal Broadband Router Cisco uBR10012:
- Software configuration manual (240 pages) ,
- Hardware installation manual (98 pages) ,
- Troubleshooting manual (86 pages)
Table of Contents
Advertisement
Chapter 3
Installing the Cisco uBR10012 Router
Tip
If you have experience using Cisco routers, consider configuring the router by using the procedure
described in the
To cancel the configuration dialog, press Ctrl-C, or you can let the dialog help you perform one of two
configuration types:
•
•
You can run the setup facility any time you are at the enable prompt (#) by entering the command setup.
Configuring the System Using System Configuration Dialog
Use the following procedure to perform a basic configuration using the System Configuration Dialog:
Step 1
The dialog starts by asking if you want to continue with the configuration dialog. Enter Yes. To return
to the enable prompt, enter No.
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
Enter Yes to perform a basic management setup. Enter No to perform an extended configuration setup.
Step 2
Would you like to enter basic management setup? [yes/no]: yes
Specify a hostname. The hostname becomes part of the IOS prompt.
Step 3
Enter host name [Router]: my-router
Specify a secret password. It appears in encrypted form in the configuration file.
Step 4
Enter enable secret: my_secret
Specify the enable password. It is used if you did not assign a secret one.
Step 5
Enter enable password: my_password
Specify the password to use for telnet sessions.
Step 6
Enter virtual terminal password: my_vt
Step 7
At the configure system management prompt, enter No.
Configure System Management? [yes/no]: no
Step 8
If you want to access the router using SNMP, enter Yes at the prompt:
Configure SNMP Network Management? [yes]: yes
Step 9
Specify an SNMP community string.
Community string [public]: public
OL-18259-09
"Basic Configuration in Global Configuration Mode" section on page
Basic configuration setup configures only enough connectivity for management of the system.
Extended setup asks you to configure each interface and is not appropriate for configuring the
Cisco uBR10012 router. For more information, see the Cisco IOS Configuration Fundamentals
Configuration Guide.
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
Configuring the Cisco uBR10012 Router at Startup
3-65.
3-63
Advertisement
Table of Contents
Troubleshooting
