Cisco Ubr10012 Universal Broadband Router Modules; Fan Assembly Module; Ac Power Entry Modules - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual
Cisco systems universal broadband router hardware installation guide
Hide thumbs
Also See for Universal Broadband Router Cisco uBR10012:
- Software configuration manual (240 pages) ,
- Hardware installation manual (98 pages) ,
- Troubleshooting manual (86 pages)
Table of Contents
Advertisement
Chapter 1
Cisco uBR10012 Universal Broadband Router Overview
Cisco uBR10012 Universal Broadband Router Modules
The following section describes the modules used in the Cisco uBR10012 router. For a list of field
replaceable units (FRUs) used in this chassis, see
Fan Assembly Module
The Cisco uBR10012 chassis uses a fan assembly module containing fans to supply cooling air to the
chassis. The fan assembly connects to the chassis through a blind mate connector that plugs into the
cable assembly and then into the chassis backplane. The fan assembly modules can be identified by the
product part numbers. The fan assembly module supported on the Cisco uBR10012 chassis is:
•
•
For information on installing, removing and replacing the fan assembly module, see
Universal Broadband Router Fan Assembly
AC Power Entry Modules
The Cisco uBR10012 router is shipped with two AC power entry modules (AC PEMs) that provide
power supply to the system. One AC PEM module is sufficient to provide power for a fully configured
chassis. However, if one AC PEM module fails, the other AC PEM module automatically begins
providing power to the entire chassis, without impacting the system operation.
The AC PEM modules use a standard 200–240 VAC (50 or 60 Hz) input power obtained through power
receptacles on the front panel of each PEM. The two AC PEMs convert the AC power to provide filtered,
redundant, and load shared DC power to the Cisco uBR10012 chassis. The AC PEM modules can be
identified by their product part numbers.
The AC PEM modules supported on the Cisco uBR10012 chassis are:
•
•
For information on installing, removing and replacing the 2400 W AC PEM module, see
Module for the Cisco uBR10012 Universal Broadband
For information on installing, removing, replacing the 3300 W AC PEM module, and migrating from the
2400 W AC PEM to the 3300 W AC PEM, see
Universal Broadband Router.
OL-18259-09
Fan Assembly Module (UBR10-FAN-ASSY=)
Fan Assembly Module (UBR10012-FAN-PLUS=)
AC PEM Module (UBR10-PWR-AC=)
AC PEM Module (UBR10-PWR-AC-PLUS=)
Cisco uBR10012 Universal Broadband Router Modules
"Cisco uBR10012 Router FRU
Module.
Router.
3300 W AC Power Entry Module for the Cisco uBR10012
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
Resources".
Cisco uBR10012
AC Power Entry
1-13
Advertisement
Table of Contents
Troubleshooting
