Huawei NE05E Hardware Manual page 456
Hide thumbs
Also See for NE05E:
- Quick installation manual (30 pages) ,
- Quick installation manual (19 pages) ,
- Quick installation manual (28 pages)
Table of Contents
Advertisement
HUAWEI NE05E,NE08E
Hardware Guide
Fold the part
Fold the printed part along the dotted line according to the directions shown in
(2) of
The length of the narrow part is based on an external cable diameter of 2.6 mm,
after this part has been stuck to the back of the label, it may not overlap the
entire printed part.
After the printed part of the label has been folded, the narrow part of the label
should be covered completely, as shown in
Fold the Label
Fold the label upwards along the dashed line, and attach it. After being attached,
the label is shaped as (3) of
?.2. attaching the Label to the Power Cable
This section describes the positions where the labels should be attached on the
power cables and the means by which the cable ties are bound to the power
cables.
Remove the label from the bottom page, then attach it to the identification plate
on the cable tie. The label should be stuck to the rectangular flute, and should be
stuck to only one side of the identification plate. Make sure to attach the labels on
the same side of the identification plates. The cable ties are bundled 2 cm from
the connectors, and other positions are allowed in special circumstances.
Cable ties should be bundled on both ends of a cable. After the bundling, the
finished identification plate should be on top of the cable in horizontal cabling, or
on the right side of the cable in vertical cabling. Make sure the label is facing out,
as shown in
Figure 4-23 Appearance of attached labels on power cables
Issue 05 (2023-03-31)
Figure
4-22.
Figure
4-23.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure
Figure
4-22.
4-22.
448
Advertisement
Table of Contents
