Table of Contents
Advertisement
Available languages
Available languages
E-42
SIMEAS Q80 7KG8080
10.4.5.2 Exchanging the removable drive
a) Retrieving data and exchanging the internal data carrier with the PC connected
· Once the data carrier has been exchanged, the measurement must be prepared and started over again.
b) Retrieving data via modem or network
· Select the device in the "Data transfer"-dialog.
· Run a search for measured data present.
· Transmit the measured data.
· Delete individual data sets or the entire disk.
· Data transfer can take place either during a running measurement or with the measurement stopped. It has no
effect on the running measurement.
10.4.5.3 Notes on the use of the removable hard drive
ScanDisk
Check your µ-Disk(s) regularly for errors and correct these, if applicable, using ScanDisk under Windows or with a
similar service program.
Removing from PC
The CF-Card data carrier may only be removed from the slot after it has been logged out from the system.
Failure to announce impending removal of the card may result in a crash of the operating system and the hard drive
will thus be rendered unreadable. If this happens, Windows must be restarted.
Known problems and limitations
Please proceed as follows in case of problems with the Compact Flash-Cards:
· First, format the medium using a PC.
· If your PC has no CF-card slot, then it's enough to erase the medium in the dialog "Data transfer".
· Autostart configurations are stored on the CF-card, for which reason autostart is not possible without such a
card!
· A storage medium with up to 32 MB used a the device hard disk may be formatted neither with Win95b's 32-bit
FAT, nor with WinNT/2000's NTFS!
· If SIMEAS Q80 7KG8080 has an autostart configuration which uses the µ-Disk, an error will occur if this disk is
missing upon activation. Switch the device off, insert a µ-Disk and re-activate the device.
Note
Power Quality Recorder SIMEAS Q80 7KG8080, Operating instruction
E50417-B1074-C419-A1, Release 07.05.2010
During a CF-card's start-up phase, task switching on the processor must be disabled,
regardless of what the disk type is. The duration of the disabling is approx. 2-3 s if a hard drive
is inserted; for a Flashcard it's about 50 ms.
Advertisement
Chapters
Table of Contents
