Table of Contents
Advertisement
Heating/Cooling type
cool only
To configure the fan type
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
Type.
The Fan Type screen appears.
3. Select a fan speed.
Note:
The desire option may be "grayed-out" whenever there are insufficient outputs to support this function.
Verify I/O is configured appropriately.
To configure sensors
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
Sensors.
The Sensors screen appears.
Equipment configuration
Table 21: 2-Pipe single coil
Controls
Options
On/Off
Normally closed
Normally open
Floating
Modulating
Control
Setting
> Equipment > Equipment & I/O > Equipment > Fan
Figure 31 Fan type
> Equipment > Equipment & I/O > Equipment >
EQUIPMENT CONFIGURATION
Description
•
Set Valve output type as N.C
•
Set Valve output type as N.O
•
Set output type Direct or Reverse
•
Set Valve run time
•
Set Min position when enabled
•
Enable sync at mid night
•
Set min output when enabled
•
Use Stage 1 cool as enable
•
Set output type Direct or Reverse
•
Set Min output of Modulating
valve
•
Set Max output of Modulating
valve
55
- Quick Links:
- Terminal Assignment
- I/O Terminal Assignment
Hide quick links:
Advertisement
Table of Contents
