If you aren't sure what programming options have been set in the scanner, or if you
want the factory default settings restored, refer to
page 175.
Troubleshoot a Cordless System
Troubleshoot a Base
Note: Visit the Services and Support section of our website (sps.honeywell.com) to check
for the latest software for both the scanner and the base.
If your base is not functioning properly, review the following troubleshooting
guidelines to try to isolate the problem.
Is the red LED on?
If the red LED isn't illuminated, check that:
•
•
Is the green LED on?
If the green LED isn't illuminated, check that:
•
•
•
•
Troubleshoot a Cordless Scanner
Note: Make sure that your scanner's battery is charged.
Visit the Services and Support section of our website (sps.honeywell.com) to check
for the latest software for both the scanner and the base or Access Point.
Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the symbols:
•
•
Voyager XP User Guide
into your application. Refer to
further information.
The power cable is connected properly and there is power at the power source.
The host system power is on (if external power isn't used).
The scanner is correctly placed in the base.
There is external power or 12 volt host power.
Charge mode is turned on.
page
43)
The battery is not bad or deeply discharged. In some cases, the scanner's battery
may trickle charge to bring it into an acceptable level and then transition to a
normal charge cycle.
Aren't smeared, rough, scratched, or exhibiting voids.
Aren't coated with frost or water droplets on the surface.
Prefix/Suffix Overview
(See "Beeper and LED Sequences and Meaning" on
beginning on page 93 for
Reset the Custom Defaults
on
211